ICD Adds Termination Planner to Stackup Software


Reading time ( words)

In-Circuit Design Pty Ltd (ICD), Australia, developer of the iCD Stackup and PDN Planner software, has released a new Termination Planner feature for its Stackup software.

The key pillars of high-speed design stability are stackup impedance, PDN impedance, and matched impedance. ICD currently has the first two issues covered with the Stackup and PDN Planner software. And now, the Termination Planner feature has also been introduced to complement the existing software.

Barry O screen shot.JPG

“For perfect transfer of energy and to benefit from the highest possible bandwidth, the impedance of the driver must match the impedance of the transmission line and be constant along its entire length,” said CEO Barry Olney. “Unfortunately, using mainstream PCB layout software, one really has no idea what the driver impedance is, let alone the capability to match the driver to the unknown impedance of the transmission line.”

The ICD Termination Planner addresses this issue. Firstly, the attributes required to determine the source impedance of the driver, are extracted from an IBIS model IV curves. Then the required series termination resistance is calculated, based on a distributed system, to match the transmission line for the selected layer in the iCD Stackup Planner. If the IBIS model is not available (or produces an error) the user may use Generic models to calculate an approximate series termination. Generic models include: typical DDRx, Display Port, ECL, HDMI, LVCMOS and LVTTL gates, Mini-LVDS, NAND Flash, PCI, SDRAM, HSTL and SSTL models.

The number of loads on the transmission line also has an affect on the required value of series termination; as the IC input inductance and capacitance tend to roll-off the signal rise time. This can be adjusted from 1 – 6 loads and automatically compensated for in the calculation.

This new feature will be delivered to current ICD support customers as part of an interim upgrade and will be also made available as part of a new Stackup Planner acquisition.

A quick demonstration of the new ICD Termination Planner can be viewed here.

About In-Circuit Design Pty Ltd

In-Circuit Design Pty Ltd, based in Australia, developer of the ICD Stackup and PDN Planner software, is a PCB design service bureau and specialist in board level simulation. For further information or to download a free evaluation of the software, please visit www.icd.com.au

 

Share

Print


Suggested Items

A Library Management Cautionary Tale

02/12/2021 | Steven V. Chavez, CID+
The library management of footprints, land patterns, or cells—however you refer to them in your ecosystem—is one of the most critical items in the foundation of any PCB or CCA design. When I was asked to write an article on this topic, so many thoughts and experiences instantly flooded my mind. After 30+ years of designing PCBs throughout the industry, I have my share of experiences and stories about footprints. One particular experience stands out.

Wild River ISI-56 Platform Accelerates SerDes Testing

02/02/2021 | Andy Shaughnessy, Design007 Magazine
I recently spoke with Al Neves, founder and CTO of Wild River Technology, about the release of their new ISI-56 loss modeling platform. Al explains why it was so critical that this tool meets the stringent requirements of the IEEE P370 specification (which he helped develop), and why he believes this is currently the best tool for SerDes testing and characterization.

Seven Tips for Your Next Stackup Design

02/01/2021 | Eric Bogatin, University of Colorado, Boulder
Rarely do we have the luxury of designing a board just for connectivity. When interconnects are not transparent, we must engineer them to reduce the noise they can generate. This is where design for signal integrity, power integrity and EMC—collectively high-speed digital engineering—are so important. Eric Bogatin offers seven tips for stackup design.



Copyright © 2021 I-Connect007. All rights reserved.