Researchers Gain Key Insight Into Solar Material’s Soaring Efficiency
May 24, 2019 | University of Colorado BoulderEstimated reading time: 2 minutes
The rows of blue solar panels that dot landscapes and rooftops are typically made out of crystalline silicon, the workhorse semiconductor found in virtually every electronic device.
Over the last decade, Colorado State University researchers have led pioneering studies into improving the performance and cost of solar energy by fabricating and testing new materials that extend beyond the capabilities of silicon. They have focused on a material that shows promise for replacing silicon, called cadmium telluride.
In collaboration with partners at Loughborough University in the United Kingdom, researchers at CSU’s National Science Foundation-supported Next Generation Photovoltaics Center have reported a key breakthrough in how the performance of cadmium telluride thin-film solar cells is improved even further by the addition of another material, selenium. Their results were published in the journal Nature Energy earlier this month and are the subject of a “News and Views” article.
“Our paper goes right to the fundamental understanding of what happens when we alloy selenium to cadmium telluride,” said Kurt Barth, a director of the Next Generation Photovoltaics Center and an associate research professor in the Department of Mechanical Engineering.
Mystery Solved
Until now, it was not well understood why the addition of selenium has clocked record-breaking cadmium telluride solar cell efficiency – the ratio of energy output to light input – of just over 22 percent. Together with CSU collaborators W.S. Sampath and Amit Munshi, Barth and an international team have solved that mystery. Their experiments revealed that selenium overcomes the effects of atomic-scale defects in cadmium telluride crystals, providing a new path for more widespread, less expensive solar-generated electricity.
The cadmium telluride thin films that the CSU team makes in the lab use 100 times less material than conventional silicon solar panels. They are thus easier to manufacture, and they absorb sunlight at nearly the ideal wavelength. Electricity produced by cadmium telluride photovoltaic cells is the lowest-cost available in the solar industry, undercutting fossil fuel-based sources in many regions of the world.
According to the paper, electrons generated when sunlight hits the selenium-treated solar panel are less likely to be trapped and lost at the material’s defects, located at the boundaries between crystal grains as they are grown. This increases the amount of power extracted from each solar cell. Working with materials fabricated at CSU via advanced deposition methods, the team discovered this unexpected behavior by measuring how much light is emitted from selenium-containing panels.
Comparing Luminescence
As selenium is not evenly distributed across the panels, they compared luminescence emitted from areas where there was little-to-no selenium present and areas where the selenium was very concentrated.
“Good solar cell material that is defect-free is very efficient at emitting light, and so luminesces strongly,” said Tom Fiducia, the paper’s lead author and a Ph.D. student at the University of Loughborough, working with Professor Michael Walls. “It is strikingly obvious when you see the data that selenium-rich regions luminesce much more brightly than the pure cadmium telluride, and the effect is remarkably strong.”
The National Science Foundation has supported the work of CSU’s Next Generation Photovoltaics Center since 2009.
Suggested Items
Zentech’s Board of Directors Announces the Return of Matt Turpin as President and CEO
04/22/2024 | Zentech ManufacturingTurpin draws upon over 35 years of experience in the electronics industry and has an 18-year history with Zentech. He previously served as President and CEO from 2006 to 2019 after which time he has remained active in the EMS industry as an advisor to Zentech and other industry organizations.
SEMI Talent Forum 2024 to Help Build Next-Generation Chip Industry Workforce
04/09/2024 | SEMIPost-graduates and onboarding talent will connect with local companies to explore semiconductor industry career paths and employment opportunities at the SEMI Talent Forum, May 1, 2024 at the University of Swansea.
Indium Corporation Technical Manager to Present at SMTA Taiwan Tech Forum
03/12/2024 | Indium CorporationIndium Corporation Senior Area Technical Manager Jason Chou will present at the SMTA Taiwan Tech Forum on March 26 in Taoyuan City, Taiwan. Chou’s presentation will highlight the growing demand for high reliability and low-temperature solder solutions brought on by the rapidly developing electric vehicle (EV) and artificial intelligence (AI) industries.
Fujitsu, Delft University of Technology Establish New Quantum Lab
01/26/2024 | JCN NewswireFujitsu and Delft University of Technology today announced the establishment of the Fujitsu Advanced Computing Lab Delft at Delft University of Technology, an industry-academia collaboration hub dedicated to the development of quantum computing technologies.
Foundations of the Future: Awarding Scholarships and Awards in 2023
01/24/2024 | IPC Education Foundation -- Column: Foundations of the FutureProviding scholarships and awards to hard-working students who excel academically, demonstrate a commitment to electronics manufacturing, and are active members of the IPC student network, supports the overall mission of the IPC Education Foundation, which is to develop a talent pipeline for the industry.