Goodbye to Trial and Error?


Reading time ( words)

All the time you spend at the production line for trial-and-error runs, just to get your production board right, takes away from your real production time. It comes on top of the time spent for trial and error at the screenprinter, and any other equipment in the line. All this can take an hour or more for each production board but, with all the tools now available, it can easily be significantly reduced. In addition, though, there are time-consuming actions (like loading all the feeders) to get right before the first error-free board comes out of the machine.

So, how do you minimize the whole trial-and-error process to ensure that, when a program starts up and feeders and toolbits are already on the system, the first board coming out of the machine is immediately good?

A perfect first board would mean that the correct components were all picked from the correct feeder and placed on the correct location at the correct placement angle. Guaranteeing this means ensuring that all the many pre-defined variables are correct: enough paste, exact board positioning, precise artwork, correct components picked by the correct toolbits and placed exactly. The more variables that are incorrect, the longer the ramp-up will take. The more programs each shift that require correcting, the shorter your effective production time and thus fewer boards produced. And during ramp-up, it’s better that the system stops to signal a fault than finding it out at the end during board test. It also helps save ramp-up time if all components are actually picked to get the program started immediately without false starts.

Read the full column here.


Editor's Note: This column originally appeared in the January 2014 issue of SMT Magazine.

Share




Suggested Items

How to Minimize Quoting Time and Increase Accuracy in EMS Production

03/30/2022 | Mark Laing, Siemens Digital Industries Software
New product introductions (NPIs) and customization have been increasing rapidly over the past few years—with the results that the already-small profit margins in electronics assembly are shrinking even further. Fifteen years ago, the PCB was the product. Today, most products are a system, with multiple PCBs, cables, and enclosures. Many manufacturers want to provide turn-key products that have multiple BOMs, making the assembly process even more complicated.

The Impact of Obsolescence and Shortages on Counterfeit Risk

01/19/2022 | Vernon Densler, Sourceability N.A. LLC
While obsolescence and shortages have always been an issue, recent large-scale disruptions have made the electronic components supply chain even more volatile. Since last December, the global chip shortage has caused pricing shifts, lead time delays, and widespread stockouts. The shortage is bringing a higher-than-normal number of counterfeit parts into the supply chain. To adequately address the problem, it is important to understand its root causes, exacerbating factors, and how its impact can be avoided.

ProMetrics: An Easy, Smart Solution

01/05/2022 | I-Connect007 Editorial Team
Rehm's Michael Hanke speaks about the product on process and the advantages of live process monitoring with ProMetrics, Rehm’s newest monitoring tool, which is brand new and unique in the market. Users say that it’s easy to use and, more importantly, that it provides the security in a system they are looking for.



Copyright © 2022 I-Connect007. All rights reserved.