Basic Principles of Polymer Thick Film Flexible Circuits


Reading time ( words)

Polymer thick film (PTF) technologies have been used to manufacture printed circuits for decades. In fact, some of the very first circuits ever produced in volume were made by printing conductive inks patterned on an insulating substrate using a stencil. While the versatile nature of the materials used and the simplicity of the manufacturing process have made possible its continued use for more than six decades. In more recent decades, the technology has seen extensive use in the manufacture of inexpensive, polyester film-based membrane switches for electronic devices of every imaginable type, from hand-held calculators and computer keyboards to household appliances including microwave ovens and washers and dryers and beyond.

Polymer thick film circuits are similar in many ways to their rigid and flexible counterparts; however, because of the materials and processes, they have their own very specific design rules. Because most PTF processing is most commonly based on screen printing technology, the limits of design are intrinsically linked to the printed ink’s processing considerations and limitations. For example, there are the unique processing properties for conductive and resistive as well as insulating inks in terms of their thixotropy, which influence their printability. There is also the important consideration of the final values for the conductivity and/or resistivity of the ink used when cured. In addition, there are also the limits of the screen printing materials and the processes used.

Traditional screen printing methods are typically limited to the production of relatively course features (e.g., 250 µm). However, very fine-featured screen printed circuit technology has been reported down to ranges closer to 125 µm. For the foreseeable future, screen printing will remain an important technology for the manufacture of PTF circuits, both rigid and flexible. That said, inkjet printing is well positioned to augment time honored screen print methods. It also opens the door to realizing the possibility of producing circuits economically at a run unit of one, which has been one of the ideals of manufacturing. 

Read the full article here.


Editor's Note: This article originally appeared in the June 2014 issue of The PCB Magazine.

Share

Print


Suggested Items

Streamlining Inspection and Verification

01/23/2020 | Barry Matties, I-Connect007
Barry Matties speaks with Vladi Kaplan, VP of marketing for CIMS, about the company’s newest verification station, the benefits operators will see from its colorized real-time video, and how it makes verification much faster and much more efficient for companies pushing 100% inspection.

CES 2020: Here We Are Again

01/07/2020 | Dan Feinberg, Technology Editor, I-Connect007
Here we are again at what is probably the largest and most fascinating technology event globally—CES. It is hard for me to believe that as a post-semi-retirement activity for me, I have been attending and writing about CES for over 20 years. The much progress that has taken place is immense, and the rate of change has also accelerated.

Calumet Electronics and Averatek Team Up on A-SAP

12/02/2019 | Nolan Johnson, PCB007
Nolan Johnson talks with Brian Hess of Calumet Electronics and Mike Vinson of Averatek about the new, insertable additive processes that the companies are working on together to help factories running primarily subtractive processes to quickly convert to very high-density interconnect (HDI) features, including trace and space from 2.5-mil line and space to 1-mil line and space and below.



Copyright © 2020 I-Connect007. All rights reserved.