Flying Probe - Indirect Testing vs. Military


Reading time ( words)

Introduction

The use of flying probe testers has become increasingly popular in recent times, mainly due to the affordability of the equipment and also the reduced cost of testing, as no dedicated or “bed of nails” fixture is required. When using flying probes to test military product, one must be diligent to make sure the test method is allowable. Grid test machines provide full net to net testing for isolation of all nets and full continuity of individual nets.  This is referred to as full simultaneous test.  When a flying probe is used there are two modes of operation: Direct or indirect.

Direct Testing

When a direct test is used the machine will test every board in resistance mode, meaning that every net will be resistively tested for both opens and shorts. Each board will take the same time to test. When the isolation (shorts) test is performed, nets will be tested using an adjacency window. This is different than a bed of nails whereby which each net is tested simultaneously to all other nets using the voltage and isolation resistance thresholds. With a flying probe only nets within the adjacency window are tested to others. Industry accepted practice for this adjacency window is 0.050” (1.27 mm). Also to be considered is the type of adjacency used.  Standard practice is X,Y adjacency or “line of sight,” meaning only on the same layer. If Z-axis adjacency is added, the adjacency window becomes three-dimensional and isolation testing is done not only on the same layer, but within the adjacency window on layers above and below.

Read the full column here.


Editor's Note: This column originally appeared in the June 2014 issue of The PCB Magazine.

Share

Print


Suggested Items

Chapter 2 Excerpt from the Book ‘Thermal Management: A Fabricator's Perspective’

12/21/2020 | Anaya Vardya, American Standard Circuits
Insulated metal PCBs (IMPCB) or metal-clad PCBs (MCPCB) are a thermal management design that utilizes a layer of solid metal to dissipate the heat generated by the various components on the PCBs. When metal is attached to a PCB, the bonding material can either be thermally conductive but electrically isolative (IMPCBs or MCPCBs), or in the case of RF/microwave circuits, the bonding material may be both electrically and thermally conductive. The reason that RF designers usually have the bonding material thermally and electrically conductive is that they are using this not only as a heat sink but also as part of the ground layer. The design considerations are quite different for these different applications.

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

12/18/2020 | Andy Shaughnessy, Design007 Magazine
Some years, the middle of December is marked by a distinct lack of news in PCB design, fabrication and assembly. Much of the industry often takes off around this time to get a head start on the holidays, or to squeeze in a much-needed vacation. But 2020 is not one of those years. Most of us aren’t traveling anywhere farther than the refrigerator this year, and everyone seems to still be working, albeit from their home offices. And companies in the PCB community continue to make news.

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

12/11/2020 | Nolan Johnson, I-Connect007
This week’s mainstream news was dominated—well, my personalized online news feed was, at least—by ballistics. SpaceX was in the news daily for lobbing multiple pieces of iron, even as their CEO took his household suborbital, leaving California and touching down in Texas. Pandemic numbers charts continue their skyward trajectory worldwide. The ever-present military tests and technology demonstrations, seemed a bit more commonplace this week as well. Worldwide political news, in general, seemed to follow parabolic curves like an Australian boomerang, veering off in unexpected ways only to suddenly cut a curving path and return.



Copyright © 2021 I-Connect007. All rights reserved.