Beyond Design: Stackup Planning, Part 4


Reading time ( words)

In this final part of the Stackup Planning series, I will look at 10-plus layer counts. The methodology I have set out in previous columns can be used to construct higher layer-count boards. In general, these boards contain more planes and therefore the issues associated with split power planes can usually be avoided. Also, 10-plus layers require very thin dielectrics in order to reduce the total board thickness. This naturally provides tight coupling between adjacent signal and plane layers reducing crosstalk and electromagnetic emissions.

In high-speed digital designs, transient ground currents are the primary source of both unwanted noise voltages and radiated emissions. In order to minimize these emissions, the impedance of the ground should be minimized by reducing the inductive loop area. Inductance is directly proportional to the length of the conductor, so keep the loop area as short as possible.

To minimize inductance, two conductors (signal traces or ground planes) that carry current in the same direction should be separated. However, two conductors that carry current in the opposite direction (such as signal and ground planes or power and ground planes) should be positioned as closely as possible. Both these cases also help eliminate crosstalk.

Here are some additional rules for high-speed design:

  1. Use multiple ground planes, where possible, rather than power planes, in the stackup to isolate signal layers.
  2. Place stitching ground vias close to every signal transition (via) to provide a short current return path.
  3. Spread numerous ground stitching vias around the board to connect the multiple ground planes through a low impedance path.
  4. Don’t use ground pours on signal layers as this reduces the impedance of nearby traces. If you must, in order to balance copper, separate the signal and pour by 20 mils.

If power planes are used as reference planes, then the return current must transverse stitching capacitors in order to jump between ground and power planes. The current flowing through these stitching capacitors will create a voltage drop across them. These voltages may radiate adding to system noise problems. 

To read this entire column, which appeared in the October 2015 issue of The PCB Design Magazine, click here.

Share




Suggested Items

Pulsonix Collision Avoidance to Bring Mechanical Capabilities Into ECAD

05/19/2022 | I-Connect007 Editorial Team
The I-Connect Editorial Team recently spoke with Bob Williams, managing director of Pulsonix. He discussed some of the new features in the upcoming version of the Pulsonix PCB design tool, Version 12, including collision avoidance and other 3D options that allow certain MCAD functions within the ECAD environment.

A Textbook Look: Signal Integrity and Impedance

05/18/2022 | Pete Starkey, I-Connect007
Believing that I knew a bit about signal integrity and controlled impedance, I was pleased to take the opportunity to connect with an educational webinar that I hoped would extend my knowledge. In the event I was surprised at how little I actually knew, and the webinar was an excellent learning opportunity. The webinar was introduced and expertly moderated by Anna Brockman of Phoenix Contact in Germany.

The Printed Circuit Designer’s Guide to… Stackups: The Design within the Design

04/18/2022 | Skyler Sopp, Mercury Systems
If you have ever contemplated crosstalk, eye closure, power loss, or a list of other issues defined in this textbook, then you also need to understand what, why, and how stackups can and will impact your circuit’s performance. After all, the stackup is one of the few things that directly touches every single part of your design; therefore, you must set yourself up for the highest probability of success by establishing a strong foundation through a well-designed stackup.



Copyright © 2022 I-Connect007. All rights reserved.