LPKF Launches Entirely New Flex Drilling & Cutting Laser


Reading time ( words)

Electronics manufacturing equipment manufacturer and laser specialist LPKF Laser & Electronics AG is launching an entirely new laser drilling and cutting system specifically tailored to the needs of the flexible circuit industry. The LPKF MicroLine 5000 is a UV laser-based flex drilling system with a large working area of 21” x 24” and is available in two different laser power classes, depending on customer needs for various substrates and thicknesses. The system is equipped with precise process monitoring systems as well as intelligent vision systems for fiducial recognition and alignment.

Nils Heininger, Senior Vice President at LPKF explains, “We believed that the flex drilling market was underserved with the solutions currently existing in the marketplace in terms of speed, quality and cost. With LPKF being a specialist in laser based circuit processing, we felt we can do better and serve the industry with a modern laser system that is very fast and delivers superior quality drill holes at a very low cost of ownership.” Although the system is mainly focused on high-speed drilling of both blind vias and through-holes, it is equally effective for contour cutting of flexible circuits. With a small laser beam spot size of only 20 μm, it allows for precise cuts of intricate flex circuit geometries. The laser system is operating in the UV wavelength allowing it to drill and cut delicate substrate materials with a minimal heat-affected zone. For added flexibility, LPKF’s MicroLine 5000 can also be configured for reel-to-reel handling of flex substrates.

The company will demonstrate the LPKF MicroLine 5000 system from March 15th through 17th, 2016 for the Asian FPC market at Laser World of Photonics (booth #W5.5366), at the Shanghai New International Expo Centre, and in North America at IPC APEX EXPO 2016 (booth #228), at the Las Vegas Convention Center.

About LPKF

LPKF Laser & Electronics AG manufactures machines and laser systems used in electronics fabrication, medical technology, the automotive sector, and the production of solar cells. Around 20% of the workforce is engaged in research and development.

Share

Print


Suggested Items

Why Designers Need to Be at the SMTA Additive Electronics Conference

10/18/2019 | I-Connect007
In a recent interview, Kelly Dack and Tara Dunn (Omni PCB president and conference co-chair) discussed why designers need to attend the SMTA Additive Electronics Conference. Tara will also be attending and moderating a panel discussion at the conference.

SMTA Additive Electronics Conference: Industry Trends

10/10/2019 | I-Connect007
Mainstream PCB manufacturing is often limited to 50-75 microns (mm) line and space. But the electronics industry is evolving quickly. Propelled by the demand for more sophisticated electronics, PCB design is being tasked with finer lines, thinner materials, and smaller via sizes.

Additive Electronics Conference Set for October 2019

09/18/2019 | I-Connect007 Editorial Team
Tara Dunn, president of Omni PCB and I-Connect007 columnist, and Lenora Clark, director of autonomous driving and safety technology at MacDermid Alpha Automotive, discuss what can be expected from the upcoming Additive Electronics Conference in San Jose, California, the impetus and motivation behind the conference, and who can benefit the most from attending.



Copyright © 2019 I-Connect007. All rights reserved.