Green Legislation and the Impact on Electronic Materials and Processes


Reading time ( words)

In a previous Tech Talk, I pointed out that “green” and “environmentally friendly” are illdefined terms. In general, these terms refer to manufacturing that involves the replacement of toxic substances with less toxic materials, the elimination of materials or processing steps, less consumption of chemicals (i.e., more efficient or higher yield processing), reduction of water use, reduction of energy use, less space requirement (i.e., smaller equipment footprint), recycling, and on-site recovery of materials. The following list highlights critical regulations that impact electronic manufacturing. A. An overview of regulations that impact materials and processes used in the fabrication of electronic devices.

RoHS: The RoHS Directive stands for “the restriction of the use of certain hazardous substances in electrical and electronic equipment.” This directive bans the placing on the EU market of new electrical and electronic equipment containing more than agreed levels of lead, cadmium, mercury, hexavalent chromium, polybrominated biphenyl (PBB) and polybrominated diphenyl ether (PBDE) flame retardants. Manufacturers need to understand the requirements of RoHS to ensure that their products, and their components, comply.

WEEE: Directive 2002/96/EC of the European Parliament and of the Council of 27 January 2003 on waste electrical and electronic equipment (WEEE). This regulation addresses the disposal and recycling of electronic equipment.

REACH: Regulation (EC) No 1907/2006 of the European Parliament and of the Council of 18. December 2006 concerning the Registration, Evaluation, Authorisation and Restriction of Chemicals (REACH)

Read the full article here.

 

Editor's Note: This article originally appeared in the March 2016 issue of The PCB Magazine.

Share

Print


Suggested Items

Selecting the Proper Flex Coverlayer Material

09/06/2019 | Dave Lackey, American Standard Circuits
Coverlayers are polymer materials used to cover and protect the copper traces of the flex circuit product. There are a number of different options available for protecting the circuits, and they serve different design requirements in terms of cost, performance, and flexural endurance optimization. When specifying the choice, it is critical to call out not just the type of coverlayer material but also the thickness requirement. This can be very important in certain types of constructions, especially when a flex circuit will experience dynamic flexing during use.

Chemcut: Wet Processing Equipment for the Long Haul

09/06/2019 | Barry Matties, I-Connect007
Chemcut CEO and General Manager Rick Lies speaks about the growth he has seen in the marketplace over his 18 years in the industry, and how Chemcut has been able to remain competitive in the PCB and photochemical milling spaces. Jerry Reitz, Chemcut’s HES manager, also addresses the current shift towards zero-discharge facilities.

Putting Green Into a Brownfield Facility

09/05/2019 | Nolan Johnson, I-Connect007
George Milad, national accounts manager for technology at Uyemura, talks about what is driving change in the wet process marketplace and how chemistries must fit into next-generation product design while also meeting new environmental requirements.



Copyright © 2019 I-Connect007. All rights reserved.