FEATURED NEWS AND INFORMATION:
FEATURED ARTICLES AND COLUMNS:

Recently, Dan Feinberg was invited to attend a detailed and broadly informative webinar by nScrypt titled “The Strength of 3D-Printed Electronics," which covered the status and advances in the use of 3D printing for electronic device design and manufacture. nScrypt is an Orlando-based company founded in 2002 that focuses on 3D printing. Here’s what Dan learned from each of the speakers.

From the Hill: MIL-PRF-31032 Offers a Rewarding Twist

May 26, 2020 | Mike Hill, MIL-Q-Consulting LLC

If you are fabricating PWBs to military specifications, the master drawing will state: “Fabricate to MIL-PRF-55110, MIL-PRF-50884, or MIL-PRF-31032.” This sounds very complicated on the surface, but there is a rewarding “twist” if the fabricator is certified to MIL-PRF-31032. Mike Hill explains.


COLUMNS:

From the Hill: MIL-PRF-31032 Offers a Rewarding Twist

May 26, 2020 | Mike Hill, MIL-Q-Consulting LLC

If you are fabricating PWBs to military specifications, the master drawing will state: “Fabricate to MIL-PRF-55110, MIL-PRF-50884, or MIL-PRF-31032.” This sounds very complicated on the surface, but there is a rewarding...

Quest for Reliability: New Solder, Same Old Testing

May 20, 2020 | Eric Camden, Foresite

Solder is inarguably one of the required building blocks for electronic assemblies and, apart from a few exotics, every assembly in the world has it. When it comes to meeting the lead-free requirement, opinions and historical...

It's Only Common Sense: What Will Life Be Like in the Year 2020.5?

May 18, 2020 | Dan Beaulieu, DB Management

The second half of the year 2020 (2020.5) is in the very near future. In the next few months, what will life be like in our factories and offices? Dan Beaulieu discusses changes in today's workplaces, as well as some of the good...

Advancements in Soldering Technology Featuring:

Copyright © 2020 I-Connect007. All rights reserved.