Lead-free Compatible OSPs: What Does This Really Mean?


Reading time ( words)

Introduction

The setting: Early 2008. Many fabricators and EMS providers are continuing to push programs for RoHs compliance. This, of course, requires electronic assemblies to be, among other things, free of lead-bearing materials. To adopt such a program, the surface finish, component finish and the solder used in assembly must be lead-free. While the questions surrounding these issues are many, one in particular appears more frequently: How do we know that a particular finish is truly lead-free soldering compatible? This particular question is being addressed by one of the IPC standards writing committees responsible for developing an industry standard specification of organic solderability preservatives (OSP).

The Nature of the Beast

The IPC committee made up of a cross-section of suppliers, PWB fabricators, OEMs and EMS companies is working to complete the development of IPC-4555 (standard for OSP). This committee is developing a protocol to test OSP coatings for lead-free (high-temperature) compatibility. The protocol requires that copper coupons coated with the OSP would be subjected to three lead-free reflows, then tested for wettability with an appropriate wetting balance instrument. It should be noted that after the coupons are processed through the OSP solution, the coupons shall be rinsed with DI water and dried at 105°C. Following the protocol of the ANSI-JSTD-003B, the samples shall be fluxed using the standard 0.5% activated flux and immersed in SAC305 at a temperature of 255°C for 10 seconds. Further:

  • Ten samples per test shall be run.
  • The mean and standard deviation of the maximum force achieved shall be documented.

Interestingly, the committee has also recommended that a second set of test coupons be processed under the same pretreatment conditions. This time, however, without the drying step. Again, the ANSI-JSTD-003B, wetting balance procedure to measure wettability, will be utilized.

Read the full column here.


Editor's Note: This column originally appeared in the November 2014 issue of The PCB Magazine.

Share




Suggested Items

Optimize Your Etcher for Best Image Quality

11/03/2022 | Christopher Bonsell, Chemcut
When it comes to obtaining high-quality images, many different factors come into play. Typically, most of these factors come down to your imaging equipment and cleanroom; however, there are factors involved in the etching process that can affect the quality of your image. Here are five steps to ensure your etching process is optimized for the best image quality.

Millennium Circuits on The Move

10/31/2022 | Andy Shaughnessy, Design007 Magazine
I recently met with Daniel Thau, CEO of Millennium Circuits Limited, at PCB West. This Pennsylvania-based PCB distributor has been on an expansion path lately, so I asked Daniel to introduce us to MCL and explain where the company is headed. As Daniel says, it’s all about impacting the world in a positive way.

EIPC Technical Snapshot: ‘Tremendous Uncertainty’ in Global PCB Marketplace

10/26/2022 | Pete Starkey, I-Connect007
For the past two years, EIPC’s Technical Snapshot series has kept us extremely well-informed on developments in printed circuit materials and manufacturing technologies. But what is currently happening in the global PCB market, and how is Europe and the rest of the world affected by the current world situation? The 19th chapter (coincidentally on Oct. 19) in the series gave us a privileged opportunity to find out, as two leading industry analysts presented their observations and opinions in a webinar introduced and moderated by EIPC technical director Tarja Rapala-Virtanen.



Copyright © 2022 I-Connect007 | IPC Publishing Group Inc. All rights reserved.