Tin Whiskers: Concerns & Potential Impact


Reading time ( words)

What is the biggest concern about the growth of tin whiskers? A simple answer is “uncertainty.”

Electronic system failures attributing to or related to whiskers have been reported in the past before the electronics industry was converted to lead free. With the elimination of the use of lead (Pb) in electronics in compliance with worldwide RoHS regulations, Pb-free materials including pure tin (Sn) have been used as surface coating for component leads and metal terminals, and as solder materials in making solder joints.

Pure tin makes a practical replacement to Sn-Pb as a choice of surface coating because of its economics, availability, and performance in manufacturability, compatibility, and solderability. Today, most component manufacturers offer pure tin-coated components.

On electronic system failure, as an illustration, one of the well-studied and highly publicized incidents was the TOYOTA Camry 2003 model investigation. The unintended acceleration of the vehicle speed control was reported in 2009. National Highway Traffic Safety Administration (NHTSA) initiated an investigation with the technical support of NASA Engineering and Safety Center. Destructive physical analysis of a failed accelerator pedal position sensor assembly from a consumer vehicle that was identified with a diagnostic trouble code found the presence of tin whiskers. A tin whisker had formed a 248 Ω resistive short between two terminals of the accelerator pedal position sensor of its potentiometer accelerator pedal assembly. A second tin whisker of similar length grew from a 5-volt source terminal adjacent to a pedal signal output terminal, but this whisker did not make contact with any other terminals at the time of the analysis.

Read the full column here.


Editor's Note: This column originally appeared in the November 2013 issue of SMT Magazine.

Share




Suggested Items

Solder Paste Printing and Optimizations for Interconnecting Back Contact Cells

07/26/2022 | Narahari S Pujari and Krithika PM, MacDermid Alpha Electronics Solutions
The interdigitated back contact (IBC) is one of the methods to achieve rear contact solar cell interconnection. The contact and interconnection via rear side theoretically achieve higher efficiency by moving all the front contact grids to the rear side of the device. This results in all interconnection structures being located behind the cells, which brings two main advantages. First, there is no frontside shading of the cell by the interconnection ribbons, thus eliminating the need for trading off series resistance, losses for shading losses when using larger interconnection ribbons. Second, a more homogeneous looking frontside of the solar module enhances the aesthetics.

Optimizing Test Engineering Practices for High-Mix Electronics Manufacturing

08/01/2022 | Mark Laing, Siemens Digital Industries Software
For PCB and assembly manufacturers, test engineering has become a critical factor in enhancing the profitability of new product introductions (NPIs). Given the trend toward high-mix, low-volume production, the journey from design data to an automated PCB testing program must be quicker and more efficient than ever before. In this article, we will discuss how to optimize the efficiency of the test engineering process in accordance with these new market realities.

Time to Get Serious About CMMC Readiness

07/13/2022 | I-Connect007 Editorial Team
Divyash Patel of MX2 Technology is a leading cybersecurity expert who’s sounding the alarm about getting your company into a state of readiness. But he’s not yelling fire in a theater. Whether it’s aligning with DoD’s CMMC, or just ensuring your company’s data and processes are protected, Divyash can see what’s coming. “This is a must-have compliance program,” he says. “It needs to be taken seriously and maintained.”



Copyright © 2022 I-Connect007. All rights reserved.